Home | Site Map | Net How To | Net Issues | Cisco How To | Articles | Forums | Services | Donations | Careers | About Us | Contact Us|

 

 

How to setup Amped Wireless AP manually

1. After you connect power and cable to the Amped Wireless Access Point or Repeater, run http://setup.ampedwireless.com or http://192.168.1.240.

2. Click More Setup in the left pane.

3. disabled or enable wireless LAN interface and broadcast SSID, setup data rate, SSID, channel width, channel number, and check active wireless client table.

4. Click Security to modify encryption, authentication mode, and pre-shared key

5. Click IP Settings to configure IP address.




 

Post your questions, comments, feedbacks and suggestions

Related Topics

 

  This web is provided "AS IS" with no warranties.
Copyright 2002-2015 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.